Concrete

According to major supplies, "Use of synthetic fibers for reinforcing concrete is continuously, increasing. Apparently the construction community believes there are advantages in the use of synthetic fibers in concrete." (Schupack) Synthetic fibers are used to improve crack control in concrete. Some reports say that synthetic fiber reinforced concrete (SFRC) would replace welded wire fabric in many slab-on-grade applications. But in reality if the welded wire fabric is placed properly it controls crack width better than the synthetic fiber reinforced concrete. No matter what concrete placing job is being done, there is no substitute for good concrete practices. The use of a low fiber volume mix will help control plastic shrinkage cracks and bleeding, but not give good cracking control once the crack forms. The synthetic fibers running through a crack have a poor bond providing no shear friction. Impact and toughness tests on synthetic fiber reinforced concrete imply less edge spalling will occur. The American Concrete Institute (ACI) conducted two studies on polypropylene fiber reinforced concrete, one dealing with plastic shrinkage cracking and the other on permeability characteristics. Plastic shrinkage cracking occurs when the surface water on the concrete evaporates faster than the bleed water reaches the surface of the concrete. It was determined by the plastic shrinking cracking study that polypropylene fibers helped reduce the total plastic shrinkage crack area on test panels. Also determined is that the screeding rate affects the total crack area in polypropylene reinforced concrete, while finishing operations showed no significant effects. This study also suggests the use of longer fibers (about 0.75in.) will produce less crack...